Pressed and seam welded bend with separate branch for cleaning. The stud
is fitted with a Safe take-off and fits an inspection cap.
Pressed and seam welded bend with separate branch for cleaning. The stud is fitted with a Safe take-off and fits an inspection cap. The design gives a lower pressure drop than the equivalent design using a T-piece. The stud can also be used as the connection for an SR duct.
Pressed and seam welded bend with separate branch for cleaning. The stud
is fitted with a Safe take-off and fits an inspection cap.
Circular duct.Ducts are always produced locally and can therefore have different thicknesses and other specifications per country.The ducts can be produced both with and without click function (notches).
Please specify when ordering.
Take-off without radius. With female end – fits outside a Safe fitting. Hasn’t any Click function – hasn’t any notches.
Female coupling for joining fittings.Has normally not any Click function – hasn’t any notches.Ø 80–315 can upon order be delivered with click function – i.e. with notches.
Pressed saddle with aerodynamic flow radius facing the branch.Some PSUs are pressed with one and the same tool, and fit several dimensions of main pipe.
Pressed, concentric reducer with female coupling to meet demands for short installation length...
Read more...
Pressed, concentric reducer to meet demands for short installation
length with low pressure drop and low internal noise generation.
Areas of use:
To avoid the necessity of an exact length cutting of a duct when it is difficult to take a proper measure.
Read more
...
Areas of use:
To eliminate the accurate length cutting of ducts which the ordinary NPU...
Read more...
T-piece built with PSU saddle or a fully pressed top section. Pressure drop, see graphs on page TCPUPSU Technicaldata.
X-piece, hand made with saddle PSU.Ød4 can also have a different dimension than Ød3.
